R13 Signal Red Quick Drying Spray Enamel 1L - HiChem

This HiChem R13 Signal Red Quick Drying Spray Enamel provides a vivid, high-gloss finish with fast drying times. Easy to apply and resistant to weathering, it is ideal for metal, wood, and concrete surfaces alike. Perfect for both interior and exterior projects, the R13 Signal Red finish will last for years.

QUICK DRYING SPRAY ENAMEL
A quick drying spraying enamel exhibiting high gloss, excellent interior durability and gloss retention. Suitable for interior and short term exterior use. Moderate exterior durability, corrosion resistance and gloss retention. Used for decorating items such as machinery, manufactured items, metal structures, stairs, railings, dums, general factory equipment. agricultural implements, tools, bins and much more.
Sutable on a variety of metal surfaces such as mild steel, galvanised and zinc coated steel, aluminium, as well as on timber and fibreboard etc., after application of suitable primer or undercoat.
By the addition of HiChem Enamel Hardener superior film hardness, gloss, chemical resistance and durability an
be obtained.
DIRECTIONS
Stir thoroughly before use.
wax, grease, silicone, oil and dirt prior to priming.
Primer.
SURFACE PREPARATION Remove rust and old flaking paintwork by wire brush, grinding and/or sanding. Treat Tusted and bare metal areas with Motospray Rust Remover Gel. Remover all the gloss from previously painted areas by sanding with 280-400 grit abrasive paper. Clean surface with HiChem Prepwash to remove all traces of For ferrous metals and previously painted surfaces prime with HiChem Structural Primer 3250 or Motospray Enamel Primer Surfacer if a sandable primer is required. For adhesion to non ferrous metals use Super Elch THINNING Thin Quick Dry Spraying Enamel with 15-25% by volume Enamel Thinner E250. For large surfaces and temperature is greater than 25°C replace E250 with Mineral Turps to slow drying, reduce dry over-spray and thus improve levelling and gloss. The addition of HiChem Enamel Hardener may be made at the rate of 1 part to 16 parts of unthinned Quick Dry Spraying Enamel (250mls per 4 litres). Only mix enough paint and Enamel Hardener for the job at hand. If Enamel Hardener is used less thinner will be required. APPLICATION Apply one light coat and allow to dry for 5 minutes. Then apply 1 to 2 full single coats allowing 5 DRYING TIME At 20°C, dust free - 15-20 minutes, touch dry- 1 hour, hard dry-24 hours. CLEANUP Use Enamel Thinner E250, Mineral Turps or Reducer 285.
minute drying time between coats.
STORAGE Store in a cool dry place. Always replace the lid securely after use. For further information refer to the Product Information Sheet.
SAFETY
RISK Highly Flammable. Harmful by inhalation and if swallowed. Some mixed colours and tinters contain lead
Danger of cumulative effects. Irritating to skin.
SAFETY DIRECTIONS Avoid contact with the skin and eyes and avoid breathing the vapour or dust from sanding Wear protective clothing, safety glasses and gloves. Keep away from sources of ignition-no smoking Do FIRST AID For advice contact a Poisons Information Centre (Phone 131126) or a doctor. If swallowed, do NOT not empty into drains. Keep away from food, drink and animal feeding stuffs. When using do not eat, drink or smoke
de vomiting
SPILLS/LEAKS Collect on earth, sand or absorbent material. FRE Use dry chemical, foam, or carbon dioxide to fight fire.